The goal of this lab course is to learn to build, test and design circuits with op-amps, diodes and transistors.
Keep all lab work in a large (9 1/2 X 12) quad-rule bound notebook. The notebook should be a complete record of what you did in the lab. It should show what circuit you actually built and what test were done.
Leave room for a table of contents at the beginning and record the page numbers of each lab. Number and date pages. Record as you work. For each part of the lab following this general format as appropriate.
Cross out bad work DO NOT ERASE -- USE INK.
Do not cut up the lab handout and use it for part of the write up. Glue the handout in the lab book for reference.
You may use both sides of the lab book pages, or use the right side pages for final work and left side pages as a scratch area.
There should be enough information so that an engineer not familiar with our lab could exactly reproduce your work. The lab notebook should be neat but not formal. Be sure to include units with all data and all plots. Plots and scope printouts should have carefully labeled scales drawn on both axes. Tape the lab handouts in your notebook.
When asked to compare the results of a measurement with theory, you are expected to do and show the necessary calculations in the lab book as you proceed. Bring your calculator.
The lab book should be completed during the lab period and handed in before leaving.
The labs are long and you may find yourself unable to complete the lab on time unless you do some preparation before coming. Read the lab and think about it. It may be helpful to put initial information in your lab book before the lab period.